Implement HELP command

firmware/src/commands.c

@@ -23,6 +23,10 @@ void executeCommand(CommandLine cmdLine) {
         // INIT command: Initializes connection.
         commandInit(cmdLine.arg);
     }
+    else if (strcmp(cmdLine.command, "HELP") == 0) {
+        // HELP command: Print a list of supported commands.
+        commandHelp(cmdLine.arg);
+    }
     else if (strcmp(cmdLine.command, "READ") == 0) {
         // READ command: Takes a hex address range (or single address) as argument,
         // reads data and returns it in hexadecimal ASCII format.
@@ -68,6 +72,21 @@ void commandInit(char* arg) {
     }
 }
 
+void commandHelp() {
+    uartPutLine("HELP - Supported commands:");
+    uartPutLine("HELP - HELP");
+    uartPutLine("HELP - INIT [BINARY|ASCII]");
+    uartPutLine("HELP - READ 0000:0FFF");
+    uartPutLine("HELP - WRITE 0000");
+    uartPutLine("HELP - ERASE 0000:0FFF");
+
+    // TODO remove those
+    uartPutLine("HELP - TESTREAD (only for testing)");
+    uartPutLine("HELP - TESTWRITE (only for testing)");
+
+    uartPutLine("OK");
+}
+
 void commandRead(char* arg) {
     if (arg == NULL) {
         uartPutLine("ERR READ needs an address or address range");

firmware/src/main.c

@@ -15,7 +15,7 @@ int main(void) {
     _delay_ms(100);
 
     // Write initial message via UART
-    uartPutLine("INFO -- EEPROM programmer by binaryDiv");
+    uartPutLine("INFO - EEPROM programmer by binaryDiv");
 
     while(1) {
         // Run main loop endlessly